Lighting Crew Positions

Lit for the Room.
Exposed for the Camera.

Corporate rooms are usually lit for the people in the seats. The webcast camera sees something else. An eye adapts across an enormous range of brightness and forgives color. A sensor does neither. Three numbers decide whether a presenter reads on the stream: how much light lands on the face, the ratio between key and fill, and whether the light's color matches what the camera is balanced for. Set up a throw below and see what the camera gets.

The Throw
Lumens leaving the lens. A 750 W tungsten ellipsoidal is near 10,000; a modern LED ellipsoidal runs 6,000 to 12,000.
Narrow lens tubes concentrate the same lumens into a smaller, brighter pool. 19° and 26° are the usual keynote choices from a truss.
From the fixture to the presenter's face. Light falls off with the square of this number.
LML Design Choices
What the Camera Gets
0
Marginal
Foot-candles on the face
f/4.0 at ISO 800, 1/50 s
0 lx
Lux at the face
0 ft
Pool diameter
0:1
Key to fill
0 W
Per fixture

Foot-candles on the face by throw distance

The shaded band is the camera target, 50 to 100 fc. Inverse square: doubling the throw leaves a quarter of the light.

This rig Conventional rig, same fixture
Foot-candles on the face versus throw distance for this rig and a conventional rig
View as table
ThrowThis rigConventional
01 / Level

The camera doesn't adapt. Your eye does.

A ballroom stage at 15 foot-candles looks fine from the back of the room because your eye opens up. The camera has to open its iris or add gain instead, and gain is noise. The working target for a face on a webcast is 50 to 100 fc, read with an incident meter held at the face and pointed at the camera, not at the floor.

Light falls off with the square of distance. Double the throw and a quarter of the light arrives. That is why a 30-foot throw from a truss needs a fixture four times brighter than the same look from 15 feet, and why the camera look gets set at tech with a meter in hand, not by eye from front of house.

02 / Ratio

Ratio is what shapes a face

Level buys exposure. Ratio buys the look. A key from about 45 degrees above and to one side gives a face dimension, and the fill decides how deep the shadows go. For corporate work the target is 2:1 to 3:1, roughly one to one and a half stops, which reads as flattering and natural on camera. A bright key with nothing opposite lands near 5:1 and puts dark sockets under the eyes.

The LED wall behind the stage is a light source too, and often a brighter one than the presenter. Keeping faces about a stop above the wall is what stops the camera from exposing for the screen and silhouetting the talent.

03 / Color and power

LED is the compact design

Matching the light to the camera's white balance used to cost light. Full blue correction gel on a tungsten unit throws away about 60 percent of its output. A color-tunable LED dials 3200 K or 5600 K natively and holds that color as it dims, where tungsten turns orange below half. The same foot-candles arrive from roughly a quarter of the watts, which means fewer circuits, less heat on the presenter, and less load on house power.

Two things to check on the spec: a TLCI, the broadcast color-rendering index, of 90 or better, and a refresh rate high enough that the camera shutter never catches flicker. ETC Source Four LED Series 3, Chauvet Ovation, and ARRI SkyPanel are the common calls.

< 25 fc
Underlit

Camera runs on gain. Noisy shadows, soft faces.

25 to 50 fc
Marginal

Works with fast lenses or extra gain. Little margin.

50 to 100 fc
Camera-ready

The target for faces on a webcast. Clean exposure at f/4 to f/5.6.

100 to 200 fc
Bright

Room for depth of field. Watch for squinting and hot foreheads.

> 200 fc
Overlit

Faces clip before the wall exposes. Dim the key or widen the lens.

Model notes: the beam is treated as a uniform cone, so candela equals lumens divided by the cone's solid angle, and illuminance is candela over distance squared. Real fixtures peak at center and fall off toward the edge, so expect readings within about 20 percent of these. The conventional rig is tungsten gelled to the camera's white point at 40 percent transmission and 750 W; the LED rig is 100 percent and 180 W. Room bounce is taken as 10 fc of fill when no fill light is set. Exposure uses an incident constant of 250, reported as the f-stop at ISO 800 and 1/50 s. LML operates the system the venue or lighting vendor provides; these numbers are what the crew is aiming for when they set it.

Need lighting crew?

Tell us your show date, positions, and venue. We'll staff it.

Submit a Booking Inquiry